Rarely formed Route in Silverton’s Eureka Canyon
by Mark Miller, SJMG Senior Guide
Today Dave and I headed to Dukes of Hazzard in Silverton’s Eureka Canyon. Having never been on it before, I was pretty excited to get a good look at it. It ends up being two very nice, but distinctly different pitches.
Pitch 1 begins with a nice grade 3 warm-up to a ledge. Above the ledge there are two bolts that protect an M6 looking mixed line that leads up to the obvious curtain of ice. This year the curtain comes down to a chandeliered pillar that touches, though I can’t say it is getting any support from below, as the 1-2 inch wide pencil of ice that contacts the ledge is cracked.
Being more of an ice than a mixed climber, I clipped the bolts and made the rather long step onto the pillar. A few feet up I could make 1 stem to the rock near the first bolt and a little later I could stem to the curtain. While the line looked a bit intimidating, it turned out very reasonable. After that it was a long grade 2 ramp to the next column, which has a really cool cave behind it. I thought the setting was cool and it left me completely protected from anything falling from above, so in I went.
Dave led pitch 2, a really nice, solid column of ice that led to another ramp. From there as the ice ran out he had a few more steps above in snow led to a 3 pin anchor that a party a few days before left, that made a quick and efficient exit back to our cave. From the cave it was a full length rappel back to our packs and a descent down snow covered small talus that challenged our ankles, but did nothing to diminish another great outing with a good friend.
Dropped Belay Device?
Use the Munter Hitch!
If you’re a rock climber, chances are you’ve done some multi-pitch rock climbing or are at least thinking/planning to do so in the near future. On multi-pitch climbs, you carry a lot of gear with you – cams, nuts, draws, slings, carabiners – and of course your trusted belay/rappel device. Over the years, I’ve seen people drop gear on climbs more often than you might imagine. The reality is, you’re going to drop some combination of your gear at some point in your climbing career so it pays to be prepared when you do. To be sure, dropping your #2 Camalot is a big deal as well, especially if your route offers up plenty of hand crack, but in most cases you can make do with other gear and plan your protection strategy for each pitch accordingly (if you’re climbing a trad route that is). Dropping gear like a cam, nut, or quickdraw does not normally require a higher level of technical knowledge or expertise. Conversely, dropping your belay device is a whole other matter. Your belay/rappel device is arguably the most critical piece of gear on your harness. So what happens if you drop it 3 pitches up the climb?
You can easily imagine a number of scenarios where dropping your belay could occur at the top of whatever pitch you may have finished or somewhere else along your climb. If this happens, you’ll need to be able to improvise another way to belay your partner up the pitch you’ve just finished.
Perhaps the best way to do this is with the Munter Hitch. I often use the Munter Hitch exclusively in alpine terrain because it is fast, and requires only a locking pear-shaped carabiner to build and use properly. It’s less desirable to utilize the Munter Hitch systematically for multi-pitch rock climbing, the reasons for which I’ll get into later in this article. But if you are unfortunate enough to drop your belay device 3 pitches up, it makes for an excellent solution for both you and your partner.
Building the Munter Hitch
The Munter Hitch is best created using a large pear-shaped carabiner like a Petzle Attache or a Black Diamond Rock Lock. This gives the hitch plenty of room to set itself properly on the carabiner and insures maximum efficiency for both belaying and lowering or rappelling. For belaying your partner up the pitch (standard top down belaying) it’s important to clip your Munter Hitch carabiner directly to the master point/equalization point/hot point on the anchor, and when doing so make sure that the gate of the carabiner is facing down and out (towards the climber). Orienting the carabiner in this fashion is an important step in using the Munter Hitch properly and will insure you have the best ergonomics for your belay.
Next, simply clip the rope running to your climber through the carabiner. If you’re at a ledge, you can actually do this right away without the need to pull up any additional slack in the rope like you normally would when using your traditional belay device. The pear shaped carabiner makes for a handy little ratchet the as you pull up the rope it will stack itself very neatly on the ledge – something that’s advantageous if you’re continuing up or heading down (organized ropes are important!!). After you’ve pulled up all the slack, what will become your brake strand will either be coming out of the left or the right side of the carabiner depending on how you are oriented at the belay. It doesn’t really matter which way you’ve set this up, just realized that if it’s coming out of the left side you will be using your left hand as the brake hand, and vice versa.
Next, you need to create the twist in the rope to create the loop which will then go on the carabiner to make the Munter Hitch. The written word can be difficult to explain this, so see the attached picture and/or video to get a better feel for what this looks like. In essence, using what will become the brake strand, simply make a loop/twist in the rope where the rope lays on top of itself and then rolls on to the carabiner. Once you’ve done this, you have created the Munter Hitch are are ready to belay your partner. Always remember to lock your carabiner before you start to belay!!
A Few Important Considerations about the Munter Hitch
A critical piece of information to consider when using the Munter Hitch to belay or lower your partner is that it is NOT a hands free belay device. Devices such as the Black Diamond ATC or Petzl Reverso are very common self-locking belay devices that many climbers use on multi-pitch climbs for good reason, as they allow you to operate the belay and perform other tasks all at the same time. Not so with the Munter Hitch. Never let your hand leave the brake strand while using the Munter Hitch to belay!
Another disadvantage of the Munter Hitch is that it will introduce twists into the rope – especially when you place it under a load such as a rappel or lower. Used systematically, you’ll definitely start to notice that your climbing rope will start to twist and generally be more difficult to deal with over time.
Dropping your belay device 3 pitches up a multi-pitch rock climbing can and probably will happen to you at some point in your climbing career. Practicing and mastering the use of the Munter Hitch can make the difference between successfully completing your climb, or figuring out a convoluted solution in a potentially stressful situation. In that case, you’ll also be glad you brought your cell phone and a headlamp. You’ll need them!
AMGA Certified Rock & Alpine Guide